There is an VOIP2 Port in David (but it was in Beta the last time I looked at it)
OR
you will need an additional tool which converts CAPI to VOIP (e.g. XCapi)
Because you need a free port licence to use a VOIP2 port.
So you either have to buy an additional port licence or uninstall an existing port.
Port licences are not free of charge. You have to buy them. But I can't give you any current prices because I haven't bought a port licence for a while. If you want to reassign an existing port licence, you must uninstall a currently licensed port, e.g. a CAPI port that you previously used to send and receive faxes. Document exactly how it was configured beforehand, in case you want to undo it, e.g. to switch to a network CAPI instead of the VOIP2 port.
Is it enough to delete this port ??
That should do it, yes.
To delete and/or create the port, it's best to use the seperate "Port setup"-Program that should exist as a shortcut in the "Tobit.Software" group in the windows start menu. You may also directly use \David\Install\setup.exe.
That should do it, yes.
To delete and/or create the port, it's best to use the seperate "Port setup"-Program that should exist as a shortcut in the "Tobit.Software" group in the windows start menu. You may also directly use \David\Install\setup.exe.
Not needed.
I have another little problem, I try to create an Voip2 port (PORT002), but wrongly i don't complete the installation and now I have the port installed, but i can't remove it, because it's not show me the DELETE function..
You can only remove the last one, from bottom up.
So try to uninstall P003 first, before P002
This should work
Du hast noch kein Benutzerkonto auf unserer Seite? Registriere dich kostenlos und nimm an unserer Community teil!
